spiral gear

Spiral bevel gears are usually made from hardened steel. The teeth of these gears are usually ground for a more precise finish enabling little sound at high speeds. You can specify left hand or right hand depending on the direction you should run the gears

If you have a high speed application that requires a lot of torque after that spiral bevel gears are a great option. The gears run at 90° to each other and also have “spiral” shaped the teeth which provides maximum tooth surface contact while rotating. With get in touch with spread over the whole tooth the spiral bevel gear could be run much faster than the straight tooth bevel equipment and handle harder begins and stops.

We make spiral bevel gears only for industrial applications.

Worm gears are used in large equipment reductions. Gear ratio ranges of 5:1 to 300:1 are typical. The setup is designed to ensure that the worm can turn the gear, but the equipment cannot convert the worm. The position of the worm is shallow and because of this the apparatus is held set up due to the friction between your two. The equipment is found in applications such as for example conveyor systems where the locking feature can become a brake or an emergency stop.

The model cross-section shows a typical placement and usage of a worm gear. Worm gears have got an inherent basic safety mechanism built-in to its design given that they cannot function in the invert direction.

Tags:

Recent Posts