The EP Greenhouse gear driver is a concise and lightweight reduction gear reducer with an integrated limit switch system that is ideal for assembly of a locally available electric motor. The gear motor is utilized in manually-controlled or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP gear driver is certainly rainproof and windproof. The gearbox includes a high protection course (IP65) and can be used within an ambient temperature of 0-60 °C.
The low-noise gear motor for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny ensures that the drive shaft is usually locked when the reduction gear reducer is not running. The completely sealed reduction gearbox comes with an growth chamber with a diaphragm to keep carefully the gear essential oil at a low pressure under all conditions, even at high temps. Thanks to the use of an growth chamber, the gear motor can be installed in any placement. There are no limitations, because there is no dependence on a bleed connect. The sealed reduction geared motor keeps the apparatus oil of the gearbox in ideal condition for its entire operating lifetime. The geared motor is suitable for discontinuous use, operating course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction gear motor comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can easily be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed within an built-in chamber and is usually enclosed by an impact-resistant plastic-type cover. The limit switch system is accessible and simple to adjust. The limit change system’s maximum switching range is definitely 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear motor comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gear driver for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of application of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 moments.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC standard motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive 
shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).